Holding Pattern

Orbit	The holding pattern shape is circle and the user can specify a radius for this circle. For Rotary Wing aerial assets, the radius requires to be between 1000m and 10000m while for Fixed wing the radius required to be less than 5nm.
Linear	The holding pattern is in the shape of race track (ellipse). The Bearing (angle) needs to be specified between 0-360 degrees to create the linear holding pattern. The distance value is the distance between the two corner points of the holding pattern where for Rotary wing it should be between 1000m to 10000m and for Fixed wing it should be below 5nm. Note: If the distance value is 0nm it will use the default values Fixed Wing 1 nm, Rotary Wing 1500 m.
Figure 8	The holding pattern is in the shape of the number 8